Technical data

4-9 General Setup options

Ethernet (Port Setup)

Enable Ethernet—Select if the Fiery is to be connected to an Ethernet network.

Transmission Speed—Select Auto Detect if your network environment is mixed, or

select the speed (10 Mbps or 100 Mbps) of the network to which the Fiery is attached.

Parallel Port (Port Setup)

Enable Parallel Port—Select if you want to print through the parallel port. You can

connect a single Windows computer to the parallel port and print directly to the Fiery.

NOTE: Enabling the parallel port does not conﬂict with using Ethernet or Token Ring

communication with the Fiery.

Ignore EOF Character—Available only if Enable Parallel Port is selected, this option

specifies that the Fiery should ignore end-of-file (EOF) messages. Check this box to

print PostScript files in binary format (not ASCII); under normal circumstances, the

box should not be checked. When this option is selected, the Fiery uses the parallel

port timeout value to determine when the end of the file has been reached.