Technical data

4-8 Setting up the Fiery from a Windows Computer

Network Setup

Network Setup conﬁgures the Fiery to receive print jobs over the networks that are

used at your site. If the Fiery is conﬁgured to enable more than one protocol, it

automatically switches to the correct protocol when it receives a print job. When the

parallel port and one or two network ports are enabled, print jobs can be received over

all ports at the same time.

You can view and specify the following network settings in Network Setup:

• Adapters and ports—view currently conﬁgured network adapters and port settings

• Protocols—including AppleTalk, IPX/SPX, and TCP/IP

• Print Services—including LPD printing (TCP/IP), NetWare printing (PServer),

Windows print sharing (SMB), HTTP support (WWW), and Port 9100 printing

Adapters/Ports

From local Setup only, the installed network boards are displayed. You cannot change

this information. From remote Setup, you can enable Ethernet or Token Ring. You can

also enable the parallel port, regardless of the network type you use. These options are

described in the next section.