Technical data

3-46 Performing Setup from the Control Panel

When the Fiery is installed, there is no password. If you do not create an

Administrator password, users are not required to enter a password to modify the

Setup or use the administrator functions in the job management tools. If an

Administrator password has been set previously, you are required to enter it when you

run Setup. Use the up and down buttons to select the characters and the left and right

arrow buttons to move between them (see “Types of Setup screens” on page 3-5).

For more information on Administrator access privileges, see page 2-3.

For information on controlling print jobs with the job management tools, see the Job

Management Guide.

NOTE: The Operator password can be set and changed from Fiery WebSetup or the

Command WorkStation only.

TO CHANGE THE FIERY PASSWORD:

New Password

Use the up and down buttons to select the characters and the left and right arrow

buttons to move between them. Enter characters from left to right, since the left arrow

line selection button is a delete key. The password can be any combination of letters

and numbers up to 19 characters. Choose OK when you are done. Be sure to keep

track of the password.

NOTE: The only way to remove a password that you can’t remember is to reinstall

system software.

Verify New Password

Enter the new password again exactly as before to verify that you have entered it

correctly. If you make a mistake, you are prompted to enter the password again. The

new password is effective after you save changes and reboot the Fiery.

1. Scroll the main Setup menu and choose Change Password.

2. Enter and conﬁrm the password as described below.

Change Password

Font Archiving

Setu