Technical data

3
3-31 Network Setup options
Polling Interval options
NetWare Server Poll Interval in Seconds
1-3600 [15]
Specify the interval, in seconds, at which the Fiery communicates with the Novell print
server to see if there are print jobs waiting.
NOTE: If you select a short interval, the amount of network traffic increases. This may
slow down other network jobs.
Windows Setup options
Point and Print Drivers
PS/PCL [PS]
Select the type of driver to download when setting up a printer for Windows printing.
For information about setting up a computer for Windows printing, see Getting
Started.
Network Setup
Service Setup
PServer Setup
Polling Interval
Whether you are using NDS or Bindery services, choose Polling Interval from the
main PServer Setup menu. If you do not reset the interval, the default value of 15
seconds is used.
Network Setup
Service Setup
Windows Setup
Enable Windows Printing
Yes/No [Yes]
Enabling Windows Printing enables SMB (Server Message Block), the file and
printer sharing protocol built into Windows. Enabling SMB allows the Fiery to be
listed on the network so that Windows clients can print to a particular print
connection (Hold, Print, or Direct) on the Fiery without any other networking
software. For information on how to set up a Windows computer for Windows
printing, see Getting Started. Windows printing runs via TCP/IP, so TCP/IP must
be configured on the Fiery and on all workstations that use Windows printing.