Technical data

3-18 Performing Setup from the Control Panel

will not change. If you select No, you proceed to the IP Address option, where you

manually set the IP address.

Select protocol

DHCP/BOOTP/RARP [DHCP]

This option appears only if you answered Yes to Enable Auto IP Conﬁguration.

Select the protocol over which the Fiery should search for its IP address. Both DHCP

and BOOTP allow the Fiery to obtain the Token Ring IP address and Subnet Mask

automatically. RARP obtains only the Token Ring IP address.

Depending on your network, the Fiery might be assigned a different address after you

reboot the Fiery. With the DHCP setting, the Fiery can be assigned a different address

even if it is not rebooted.

Make sure the network is already conﬁgured properly for the protocol you select.

Get Gateway Address Automatically

Yes/No [No]

Use this option to get the gateway address automatically for printing with TCP/IP.

This option appears only if you selected DHCP or BOOTP as the protocol in the

previous option.

If you select a DHCP or BOOTP protocol and later change it to RARP, you must

return to Setup and set this option to No. You can then set the address manually. This

is because RARP does not support automatic assignment of the gateway address.

IP Address

[127.0.0.1]

Enter the Fiery IP address for Token Ring. This IP address, unlike an IP address set

automatically, remains the same if you reboot the Fiery. You must change the default

127.0.0.1 to a valid address for your network. For information about setting up

printing with TCP/IP, see Chapter 5.