Technical data

3
3-11 Network Setup options
TO EXIT NETWORK SETUP:
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Port Setup options
You can enable Ethernet and parallel communication simultaneously. If the Token
Ring option is installed, you can also enable Token Ring. To configure the Fiery,
choose each port type you use and enter the settings for that port. Since network
setups are nested, the names of higher-level menus are shown in this chapter to the
left of each menu heading.
Network Setup
Port Setup
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the Fiery.
Ethernet Speed
Auto Detect/100 Mbps/10 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed, or if you do not know
the network speed. If you know the speed of the network to which the Fiery is
attached (10 Mbps or 100 Mbps), select it.
Network Setup
Port Setup
Token Ring Setup
Enable Token Ring
Yes/No [No]
Select Yes if the Fiery is to be connected to a Token Ring network.
Token Ring Speed
Auto Detect/16 Mbps/4 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed, or select the speed
(4 Mbps or 16 Mbps) of the network to which the Fiery is attached.
Exit Port Setup
Ethernet Setup
Token Ring Setup
Parallel Port Setup
Port Setup