Technical data

3
3-10 Performing Setup from the Control Panel
If the Token Ring option is installed, you have these additional options:
TO ACCESS NETWORK SETUP OPTIONS:
1. Confirm that the network cable is connected to the Fiery.
During Network Setup, the Fiery queries the network for zones, servers, and server-
based queues. If you perform Network Setup without a connected and functioning
network, default settings are used that may not meet your needs.
2. Choose Network Setup from the main Setup menu.
3. Choose Port Setup from the Network Setup menu.
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
appropriate settings.
5. If the Token Ring option is installed, choose Token Ring Setup and enter the
appropriate settings.
6. To print to the parallel port, choose Parallel Port Setup from the Port Setup menu,
and enter the appropriate settings.
7. When you have finished entering port settings, choose Exit Port Setup and then
choose Protocol Setup.
8. Enter the appropriate settings for the protocol or protocols you will use.
9. When you have finished entering protocol settings, choose Exit Protocol Setup,
and then choose Service Setup.
10. Enter the appropriate settings for the services you will use.
The options are described in detail in the following pages.
For this Network or
Connection Type:
Use this Port Setup: Use this Protocol Setup: Use this Service Setup:
TCP/IP over Token Ring Token Ring Setup TCP/IP Setup: Token Ring Setup LPD Setup
Web Services Setup
Windows Setup
IPX/SPX over Token Ring Token Ring Setup IPX/SPX Setup PServer Setup (NDS,
Bindery, or both)