Technical data

3
3-9 Network Setup options
Network Setup options
Network Setup configures the Fiery to receive print jobs over the network systems that
will be used at your site.
If the Fiery is configured to enable more than one protocol, it automatically switches
to the correct protocol when it receives a print job. When the parallel port and one or
two network ports are enabled, print jobs can be received over all of those ports at the
same time.
The available network types, and the Setup areas that pertain to them, are summarized
in the following table.
In the Setup menu, choose Network Setup, where you specify network addresses and
names to be used by workstations, servers, and the Fiery when they communicate with
each other.
The Network Setup menu includes three submenus that let you choose port types,
protocols, and network services. You must perform Port Setup and enable at least one
port.
For each item you enable, you are prompted to enter settings for that item. Default
values, where applicable, appear in this manual with square brackets.
You need to display and select options only for the network systems that are currently
used at your site. If your network requirements change, you can change Network
Setup at any time.
For this Network or
Connection Type:
Use this Port Setup: Use this Protocol Setup: Use this Service Setup:
AppleTalk over Ethernet Ethernet Setup AppleTalk Setup AppleTalk printing (PAP) is
enabled automatically.
TCP/IP over Ethernet Ethernet Setup TCP/IP Setup: Ethernet Setup LPD Setup
Web Services Setup
Windows Setup
IPX/SPX over Ethernet Ethernet Setup IPX/SPX Setup PServer Setup (NDS,
Bindery, or both)
Parallel Parallel Port Setup
——
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
Exit Network Setup
Port Setup
Protocol Setup
Service Setup
Network Setup