Technical data

1
1-11 Connecting network cable to the Fiery
Connecting network cable to the Fiery
In this section, the back panel of the Fiery is illustrated, followed by information for
connecting to the Ethernet board. For information about connecting to a Token Ring
network, see Appendix A, “Token Ring Network Option.”
Shut down the Fiery
before attaching it to any network device. If the Fiery has just
finished processing, wait 5 seconds after the system reaches the Idle state before using
the power switch to turn off the Fiery.
Back view of the Fiery X12
!
X12
10/100BaseT Ethernet (RJ-45)
Copier interface connectors