Technical data

5-9 Support for Fiery utilities

• For Windows NT 4.0, install the appropriate printer driver ﬁles (PCL or PostScript) on

the Windows NT 4.0 server (see Getting Started).

• Repeat the installation for everyone who prints to the Fiery.

Each server and workstation running the Fiery utilities with TCP/IP also needs the

TCP/IP protocol and the Fiery utility software.

Conﬁguring a Windows NT 4.0 server to support the Fiery

To conﬁgure a Windows NT 4.0 server to communicate with the Fiery, follow these

general steps. More detail is provided in subsequent sections and in your Microsoft

documentation.

• Load the TCP/IP network protocol on the server and conﬁgure it with an

IP address, subnet mask, and gateway.

• Enter the host name of the Fiery in the host database used by your system (see

page 5-10).

• Perform Fiery Setup.

• On the Windows NT 4.0 server, create a printer for each Fiery print connection,

install the appropriate printer drivers and (optionally) share the printer on the net-

work (see page 5-11).

• Enter the host name and remote printer name of the Fiery in the printer connection.

See page 5-15 for more information.

• If the Windows NT 4.0 server is also a workstation, install the Fiery utilities (see

Getting Started).