Manualshelf

Technical data

ManualsBrandsElectronics For Imaging ManualsComputer equipmentFiery X12
101102103104105106107108109110
4
4-15 General Setup options
TCP/IP
Specify TCP/IP settings. The current settings for IP address, subnet mask, and default
gateway address are displayed. For information about setting up printing with TCP/IP,
see Chapter 5.
The Fiery requires a unique, valid IP address. You can set a static address yourself, or
specify that the Fiery use DHCP, BOOTP, or RARP to obtain IP addresses
automatically.
NOTE: If you specify the DHCP, BOOTP, or RARP protocol, the Fiery reboots when
you save your changes and exit Setup. Allow the Fiery to reboot and return to Idle
before printing a Configuration page or proceeding with any other operations.
To set the subnet mask, enter one of the following values:
255.0.0.0 if the IP address starts with a number less than 128
255.255.0.0 if the IP address starts with a number from 128 through 191
255.255.255.0 if the IP address starts with a number greater than 191