Technical data

4
4-12 Setting up the Fiery from a Windows Computer
TO CHANGE PROTOCOL SETTINGS IN LOCAL SETUP:
1. Click the Modify or Advanced button next to the setting.
The Windows NT 4.0 Network Control Panel opens.
2. Click the Protocols tab.
3. Select the protocol to modify.
Unless you have installed additional protocols, the choices are AppleTalk, NWLink
IPX/SPX Compatible Transport, and TCP/IP.
4. Click Properties, make your selections, and click Apply.
5. Click OK to close the Properties dialog box.
6. Click OK to close the Network dialog box.
If you have disabled any of the protocols in this procedure, use the Bindings tab of the
Windows NT 4.0 Network Control Panel when you are ready to re-enable the
protocols.