Installation guide

1-24 Installing User Software on a Windows Computer

Setting up SMB printing on Windows NT 4.0

SMB printing (also known as Windows printing) allows you to install the PostScript or

PCL printer driver and printer description ﬁles, and print from your computer to a

particular print connection (Hold, Print, or Direct) on the Fiery EX2101. These

instructions assume you have installed the TCP/IP protocol and Client for

Microsoft Networks.

Each connection (Hold, Print, or Direct) requires a new printer driver and printer

description ﬁle. To set up printing to a second or third print connection, repeat the

following procedure, “Setting up SMB printing on Windows NT 4.0”. If you install

more than one printer, give each a descriptive name during printer driver installation,

such as Aero-Print or Aero-Hold, so you can easily identify printers.

BEFORE YOU BEGIN

• Conﬁgure the Fiery EX2101 for SMB printing in Run Setup>Network Setup>Service

Setup>Windows Setup.

SMB printing is referred to as Windows Printing in Setup on the Control Panel Map,

and on the Conﬁguration page. For more information, see the Conﬁguration Guide.

TO SET UP SMB PRINTING ON WINDOWS NT 4.0

1. Double-click Network Neighborhood.