Installation guide

4
4-19 Network Setup options
DNS Setup options
Get DNS address automatically
No/Yes [No]
Select Yes to allow the Fiery EX2101 to obtain the IP address of the DNS server
automatically. If you select Yes, you proceed to the Host name option. Select No to
assign the Fiery EX2101 a static IP address, which will not change. If you select No,
you proceed to the Primary DNS server IP address option, where you manually set the
IP address.
NOTE: Confirm the IP address of the DNS server assigned to the copier on your
network in advance.
Primary DNS server IP address
[0.0.0.0]
This option only appears if you have selected No to Get DNS Automatically. Enter the
IP address of the DNS server assigned to the copier on the network.
Secondary DNS Server IP Address
[0.0.0.0]
Specify the IP address of the secondary DNS server.
Network Setup
Protocol Setup
TCP/IP Setup
DNS Setup
DNS Setup
You can configure the Fiery EX2101 so that it can access an appropriate DNS
server. With the DNS server, when connecting the Fiery utilities or Fiery WebTools
from remote workstations to the Fiery EX2101, users need to remember only its
Server Name, which is much easier to remember than an IP address.