Installation guide

4
4-14 Performing Setup from the Control Panel
The available network types, and the Setup areas that pertain to them, are summarized
in the following table.
TO ACCESS NETWORK SETUP OPTIONS
1. Confirm that the network cable is connected to the Fiery EX2101.
During Network Setup, the Fiery EX2101 queries the network for zones, servers, and
server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
2. Choose Network Setup from the main Setup menu.
3. Choose Port Setup from the Network Setup menu.
4. Choose Ethernet Setup from the Port Setup menu, and enter the appropriate settings.
5. When you have finished entering port settings, choose Exit Port Setup, and then
choose Protocol Setup.
6. Enter the appropriate settings for the protocol(s) you will use.
7. When you have finished entering protocol settings, choose Exit Protocol Setup, and
then choose Service Setup.
8. Enter the appropriate settings for the services you will use.
For this Network or
Connection Type
Use this
Port Setup
Use this
Protocol Setup
Use this
Service Setup
AppleTalk over Ethernet Ethernet Setup AppleTalk Setup AppleTalk printing (PAP) is
enabled automatically.
TCP/IP over Ethernet Ethernet Setup TCP/IP Setup: Ethernet Setup LPD Setup
Web Services Setup
Windows Setup
Port 9100 Setup
(Windows 2000/XP/2003)
IPP Setup
(Windows 98/Me/2000/XP/
2003)
IPX/SPX over Ethernet Ethernet Setup IPX/SPX Setup PServer Setup (NDS, Bindery,
or both)