Installation guide

7
7-7 Managing Fiery Address Books
When a print job is submitted via e-mail, the Fiery EX2101 first checks the Print
address book. If the user’s e-mail address does not match any entry in the Print address
book, the job does not print. Instead, the user receives an e-mail stating that the print
job was not accepted.
The default wildcard character “@” is stored in the Print address book. This allows any
user to print to the Fiery EX2101 until the administrator adds the first entry in the
Print address book.
The administrator can manage the address books by sending an e-mail to the
Fiery EX2101 with command codes in the subject and message fields. The
Fiery EX2101 responds by e-mail to these commands with information about each
request. When managing address books, see the following table.
Task
Administrator subject
field
Administrator message field
Fiery e-mail
response subject
field
Fiery e-mail
response message
field
To retrieve
a specific
address book
#GetAddressBook
name of address book
For example:
#GetAddressBook Admin
Address Book name
of address book
For example:
Address Book Admin
List of addresses
in the specified
address book.
To add an
address to
an address
book
#AddAddressTo
name of address book
For example:
#AddAddressTo Print
name@domain
or
“display name” <name@domain>
For example:
name1@domain
name2@domain
...
end
Added to Address
Book name of address
book
For example:
Added to Address
Book Print
List of addresses
added to the
address book.
The Fiery EX2101
also lists any
addresses that
cannot be added
and includes the
reason.