Installation guide

5
5-32 Setting up the Fiery EX2101 from a Windows Computer
The remaining options are found only in remote Setup. To change them with local
Setup, use the Windows XP Local Area Connection Properties Control Panel.
Server Name—Enter the server name that will appear on the network. It can, but does
not have to, be the same name as the server name assigned to the Fiery EX2101
(see “Server Name” on page 5-5).
Comment—Enter information about the printer, up to 15 characters. These comments
are listed in the Properties of the Fiery EX2101 in Network Neighborhood. Lowercase
letters are allowed in this field.
Domain or Workgroup—Enter the workgroup or domain where the Fiery EX2101
should appear.
Ethernet WINS Server—Enter the IP address of the Ethernet WINS name server.
Broadcasts from SMB devices cannot be routed beyond their original network segment
without a WINS name server. Setting up the WINS name server is outside the scope of
this manual. To find out if a name server is available, contact your
network administrator.