Installation guide

5
5-14 Setting up the Fiery EX2101 from a Windows Computer
To set the subnet mask, enter one of the following values:
• 255.0.0.0 if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
• 255.255.255.0 if the IP address starts with a number greater than 191
NOTE: Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from those listed.
If your TCP/IP network has a gateway and users outside the gateway plan to print to
the Fiery EX2101 using TCP/IP, enter the gateway address.
NOTE: The Fiery EX2101 stores assigned IP addresses, even if you later disable TCP/IP.
If you need to assign the Fiery EX2101 IP address to another device, first set the
Fiery EX2101 address to a null address.
Services
You can configure the following network services:
LPD Printing (TCP/IP)/Enable LPD Printing Service—enable or disable LPD
print services.
NetWare Printing (PServer)/NetWare Services—specify NDS and Bindery services
(see page 5-15).
Windows Print Sharing (SMB)/Windows Printing Service—enable or disable SMB
print services.
SNMP Setup—enable or disable SNMP services (Local Setup only)
HTTP Support (WWW)/Enable Web Services—enable or disable support for Fiery
WebTools and IPP printing.
Port 9100 (TCP/IP)/Enable Port 9100—enable or disable support for Port 9100
printing.
Email Setup/E-mail Service—specify the Fiery E-mail Service.