User manual

Step 4: Slide the slot cover back toward the shutters until it meets the iris handle. Leave enough

space to move the iris handle.

Step 5: Secure the drop-in iris slot cover by tightening the screws.

Rotating the barrel assembly

Step 1: Loosen the barrel rotation knob directly behind the shutters on the underside of the

reflector housing (see Figure 9). Do not remove the barrel rotation knob.

Step 2: Rotate the barrel to the desired position (up to 25° in either direction from the centered

position).

Step 3: Once the barrel is positioned, tighten the barrel’s rotation knob to lock it in place.

Adjusting the C-clamp

The C-clamp attaches the fixture to the mounting pipe and allows you to adjust the position of the

fixture once it is mounted (see Figure 10).

Step 1: Tightly fasten the C-clamp to the yoke with the provided yoke bolt and lock washer.

Step 2: Place the C-clamp on mounting pipe, then tighten the pipe bolt to secure it.

Step 3: Loosen the C-clamp pan screw and rotate the yoke to the desired position.

Step 4: Tighten the pan screw to lock the fixture.

Figure 9

Barrel rotation knob

C-clamp

Pipe bolt

Pan screw

Yoke bolt and

lockwasher

Figure 10