User manual

E CEM+ LCD Menu 60
Appendix E: CEM+ LCD Menu
This appendix contains the entire LCD menu structure. Note that the different looks of the
screens denotes a different user level required for access.
PINNo
yes
If Valid Config
No Config R__/ 0 G__
Select Config
Config is
checked vs.
backplane On
Power UP of
CEM+
No Config R__/ 0 G__
[Setup Network]
Load Config from
Rack [__]
No Config R__/ 0 G__
Login
Enter PIN
0 0 0 0
Access
Level: Guest
Invalid
Config loaded from
Rack 1 Successful
No Config R__/ 0 G__
[Generate Defaults] Rack Number [__] Racks to Add [__] [120] Volts
Set Rack Type
[SR6]
Set First Dimmer
Dimmer [_____]
Set Module Type
Module = [D20AF]
Set Phase Balance [Balanced-3Phase]
Advanced Features
[Off]
Save Changes?
[No]
Set Group / Rack Set Group / Rack Set Group / Rack Set Input Power
Group Number [__]
Set Group / RackNo Config R__/ 0 G__
Set Group / Rack
Group Number __
Set Group / Rack
Rack Number __ *
Set Subnet Mask
[www.xxx.yyy.zzz]
Set IP Address
[www.xxx.yyy.zzz]
Network Enable
[Enabled]
Set Gateway
[www.xxx.yyy.zzz]
Set Subnet Mask
[www.xxx.yyy.zzz]
Set IP Address
[www.xxx.yyy.zzz]
Network Enable
[Enabled]
Select Rack
name >Rack Name<
Set Gateway
[www.xxx.yyy.zzz]
Enable BootP
[Disabled]
Disabled
Enabled
[Cancel]
Reboot Required
IP
Changed?
Updating Settings
Please Wait
Yes
No
Cancel
[Cancel]
Reboot Required
IP
Changed?
Updating Settings
Please Wait
Yes
No
Cancel
Access Granted
Level: User
Access Granted
Level: Guest
Access Granted
Level: Power User
Valid
Set Address Mode
[Standard]
Set Alarm Temp
[___] C
Menu Key
Access Granted
Level: Power User
Access Granted
Level: User
Access Granted
Level: Guest
No Config Menu