User manual

5 Service 46

Remove a CEM+ Module:

Step 1: Turn off rack power at the main breaker.

Step 2: Open the rack door.

• Please see Releasing and Securing Module Safety Stops (ESR Racks Only)

above if appropriate.

Step 3: Press the “eject” symbol on the right end of the spring-loaded handle and grab

the other end of the handle, pulling it until it is perpendicular to the face of the

CEM+. The CEM+ will be gently pushed out of the rack as you move the handle.

Step 4: Pull the CEM+ straight out.

Replace a CEM+ Module:

Step 1: Firmly press the new CEM+ module into the correct slot by pressing on the

outside edges until you feel the connections seat (the module face will be flush

with the other modules).

Step 2: Close and lock the Sensor rack door before applying power.

Step 3: ONLY if directed to do so by an ETC-authorized service representative, transfer

the configuration files/information to your new CEM+.

WARNING:

Do not press on the center of the CEM+ to insert it into a rack. Doing so may

result in damage to the CEM+.

ETC CEM+ R 1/ 6 G 9

[Rack OK]

Press here to get handle.

Pull handle while pressing .

Press here to insert.