User manual

chapter 6 cues 69
Labeling cues
Insight 2x allows you to use an alphanumeric keyboard to assign labels to
cues. Labels can consist of any combination of letters, numbers and sym-
bols and may be up to 16 characters long. See page 296 for information
on installing an alphanumeric keyboard.
Follow these steps to label a cue:
Note: If the cue did not previously exist, press [Record] [Enter] in step 4.
This will create the cue and label it as indicated, all in one step.
Keystrokes: Action:
1. Press [Stage] or [Blind]. Selects display mode
2. Press [Cue] [1][2] [Label]. Selects Cue 12
Prompt reads:
Type cue label
(F6 = clear to end,
F7 = last cue label,
F8 = next cue label)
3. Use the alphanumeric key-
board to type the desired
label. For example, call cue
12 “Toad exits.”
Enters cue label
Corner reads: Label Toad exits
4. Press [Enter]. Records Cue 12 with label “Toad exits”