User manual

68 Insight 2x user manual
Recording a cue using Solo
[Solo] lets you record a cue that contains some of the channels that make
up the current look, but not others . Often you will create cues by adding
to, subtracting from and modifying previously recorded cues.
Follow these steps to create a cue using Solo:
Warning: If you press [Solo] in Stage mode, unselected channels control-
ling lights on stage will go to zero.
Keystrokes:
Action:
1. Press [Stage] or [Blind].
Selects display mode
2. Press [Channel].
Prompt reads:
Select channel numbers
3. Press [2][0].
Enters channel number to mark the
start of the selected range
4. Press [Thru].
Indicates you are selecting a range of
channels
5. Press [3][0]
Selects channels 20 through 30
6. Press [Solo] .
S ets all channels other than 20
through 30 to zero
Prompt reads:
(To restore levels, press SOLO)
Select channel numbers
7. Move fader wheel; press
[Full], [Level], [+], or [–]; or use
[At] and numeric keypad to
set levels for selected chan-
nels.
Sets channels 60 through 70 to a new
level
8. Press [Record].
Prompt reads:
To record cue, select number and
press ENTER
To cancel, press CLEAR
9. Press [7].
Corner reads: Cue 7
10. Press [Enter].
Records cue 7 with channels 60
through 70
11. Press [Solo].
Restores channels other than 60
through 70 to previous levels