User manual

52 Insight 2x user manual
Channel check
Use a Channel Check to check which channel controls which light. Insight
2x allows you to check channels by selecting a single channel and setting
it at a level. Once you have selected a channel you can then advance
sequentially through the channels, checking one at a time.
Follow these steps to run a channel check:
Note: You may start a channel check with any channel. Substitute the
desired channel in step 2.
Note: If a channel is Independent, it will not Flash.
Keystrokes:
Actions:
1. Press [Stage].
Selects Stage display
Prompt reads:
Select channel numbers
2. Press [Channel] [1].
Corner reads: Chan 1
3. Press and hold [S8], Flash.
Sets channel 1’s level to 100 percent if
its current level is at or below 50
percent
or...
Sets channel 1’s level to zero if its
current level is above 50 percent
4. While holding [S8], press
[+] or [–] to select the next
or previous channel.
Flashes each channel in turn
5. Once you have checked all
the channels, release [S8],
Flash.