User manual

chapter 5 setting channel levels 51
Sneak
Sneak is a softkey that you can use to fade channels on stage to a level
you choose, in a specific time or to restore channels to the last level at
which they were set with a fader or submaster. For example, if you bring
up a cue, then change the look, you can use sneak to go back to the look
created by the original cue. If you do not indicate a time, the sneak occurs
in the default sneak time, set in System Settings.
Follow these steps to use Sneak to set a channel level:
Follow these steps to restore a channel to its last fader or submaster level:
Note: Press [Sneak] [Enter] to restore all channels to their current fader or
submaster levels.
Keystrokes: Action:
1. Press [Stage].
Selects Stage display mode
2. Press [S1], Sneak.
Selects Sneak mode
Prompt reads: Sneak mode - Select
channels, then press ENTER to
sneak, or AT to select sneak level,
or TIME to select sneak time
3. Select the channel(s) you
want to sneak and the
level to which you want it
to fade. For example,
press [5] [At] [5].
Selects channel 5. Sets level at 50
percent
Prompt reads:
Sneak mode - Select level
4. Press [Time] and enter the
time for the sneak. For
example, press [Time]
[1][0].
Selects Sneak time of ten seconds
Prompt reads:
Sneak mode - Select time
5. Press [Enter].
Fades channel 5 to 50 percent over
ten seconds
Keystrokes: Action:
1. Press [Sneak] and select
the channel(s) you want to
restore. For example,
press [5].
Selects channel 5 to sneak
Prompt reads: Sneak mode - Select
channels, then press ENTER to
sneak, or AT to select sneak level,
or TIME to select sneak time
2. Press [Enter].
Fades channel 5 back to its most
recent cue or sub level