User manual

44 Insight 2x user manual
Channel modes
Channels may be in any of the following modes . Each responds differently
to commands.
Captured channels
Captured channels are channels that you have selected and are live on
stage . They remain live until you press [Rel] to release them . Captured
channels override all other channel settings. For example, if a channel
is in a fader at 100 percent and you capture it and set it to 50 percent,
Insight 2x sets the captured channel at 50 percent. Press [Rel] twice to
release captured channels.
Selected channels
Selected channels are channels over which you have immediate keypad
control
. You can modify selected channels with [Full], [At], [+], [–], or the
fader wheel . Selected channels are displayed in yellow, and their levels
are red on white . You can select channels in all display modes .
Selected, captured channels are live channels that are under immediate
keypad control . Channels can be selected and captured only in Stage
modes . You can select channels in Blind, but they won’t be captured since
Blind mode is not live. Press [Rel] once to release selected channels.
Recorded channels
Recorded channels are channel levels that have been recorded in a cue,
group or submaster . In Stage mode, recorded levels are displayed in
green or magenta . Recorded channels may be either moving or tracked in
Blind mode (see below). Channel levels controlled by effects are displayed
in white. Channel levels controlled by submasters other than effect sub-
masters are displayed in yellow.
Moving channels
Moving channels are channel levels that change from one cue to the next .
In Stage mode, all moving channels are displayed in green . In Blind and
Tracksheet, moving channels are displayed in green if they are moving
down or blue if they are moving up.
Tracked channels
A tracked channel is a channel whose level is unchanged from the preced-
ing cue . Tracked channels are displayed in magenta.