User manual

chapter 4 patch 33
Unpatching individual dimmers
Channel zero is not an actual control channel. It functions as a holding area
in which you may store dimmers not included in your patch. Before you
begin creating a custom patch, you may find it helpful to assign all dim-
mers to channel zero. Then, when you begin patching, you can select dim-
mers from channel zero and patch them to channels as you like.
Dimmers assigned to channel zero are listed at the end of channel list
under “- -.” These dimmers are not assigned to any channel, but remain
on the patch screen.
Follow these steps to assign dimmers to channel zero in By Dimmer
mode:
Keystrokes:
Action:
1. Press [Patch].
Selects Patch display
2. If the [Dim] LED is unlit,
press [Dim] to indicate that
the next number entered
will be a dimmer.
Prompt reads:
Select dimmer numbers, then press
ENTER to assign to a channel, or
press AT to assign a level, or press
PROFILE to assign a profile
3. Use the keypad to enter
the desired dimmer num-
ber(s) Use [And] and [Thru]
if you want to select more
than one dimmer.
Prompt reads:
Select dimmer numbers, then press
ENTER to assign to a channel, or
press AT to assign a level, or press
PROFILE to assign a profile
4. Press [S6], Unpatch.
Selected dimmers are unpatched and
assigned to channel zero (- -)