User manual

352 Insight 2x user manual
Profile
Profile is softkey [S7] in the Patch display
Press [S7], Profile, to assign one of 10 profiles to a dimmer. A dimmer
may be assigned a proportional patch level or a profile.
Example: [Dim] [6] [S7], Profile, [4] [Enter] assigns profile 4 to dimmer 6.
Purge Flexi
Purge Flexi is softkey [S1] in the System Settings display
Press [S1], Purge Flexi, to recalculate the list of channels used in Flexi-
channel mode. This also happens automatically when you load a show
from disk or when you turn Flexichannel on.
Quickstep
Enable/Disable Quickstep is softkey [S1] after [S7], More Softkeys, in
the Stage and Fader displays
[S1], Quickstep, allows you to run through a show, checking all cues,
without having to wait for fades. When Quickstep is active, the faders
ignore all upfade, downfade, and wait times. Cues snap immediately to
their completed levels when you press [Go] or [Back]. Disable Quickstep
mode by pressing [S7] again, or by leaving the Stage display.
Rack Status
Rack Status is softkey [S6] in the System Status and Dimmer Status
displays
Use [S6], Rack Status, to check information about your dimmer racks,
including rack type, starting address, port information, voltage, frequency,
and ambient temperature.
Random
Random is softkey [S6] in the Blind Effect Attribute display
Use [S6], Random, to cause the step list execution to be selected and run
randomly. To cancel the Random attribute, press [S6] again.
Random Rate
Random Rate is softkey [S7] in the Blind Effect Attribute display
Press [S7], Random Rate, to cause the rate to be randomly selected and
applied to each step. The selection will be within the range defined for
Low random rate and High random rate. Rates may range from 0 to 2,000.
To cancel the Random Rate attribute, press [S7] [Clear].
Example: [S7], Random Rate, [5][0] [[S7], Random Rate, 2][0][0] to set
the minimum rate to 50 percent and the maximum rate to 200 percent.
Rate (fader)
Press the fader’s [Rate] key to allow the fader rate to be controlled by the
rate wheel.
Example: [A/B Rate] [Rate Wheel] adjusts the rate of the fade in fader A/B.