User manual

appendix d reference 351

Pause Mode

Pause Mode is softkey [S4] in the SMPTE Events display

Use [S4], Pause Mode, to interrupt the input of SMPTE time code, with-

out resetting the SMPTE event list. Press again to return to normal oper-

ation. SMPTE events may be individually executed in Pause mode by

pressing [S5], Step.

Pause Printer

Pause Printer is softkey [S2] in the Print Functions display

Press [S2], Pause Printer, to interrupt a print function. Press [S2] again to

resume printing.

Pile-on submaster

A pile-on submaster contains a specified set of channels, recorded at pro-

portional levels. Pile-on submasters interact with established channel

levels on a highest level basis.

Play Backup

Play Backup is softkey [S2] in the System Status display

Use [S2], Play Backup, to play back a recording of a selected look on

stage that is stored in a Sensor CEM.

Plus

Press [+] to increase the selected number by one.

Example: [Cue] [6] [Time] [1][0] [+] [+] sets the fade time for cue 6 to 12

seconds.

Example: [Dim] [1] [At] [7][5] [+] [+] patches dimmer 1 at 77 percent.

Positive/Negative

Positive/Negative is softkey [S1] in the Blind Effect Attribute display

Press [S1], Positive/Negative, to change the effect attribute from a pos-

itive chase (steps are at their low value when off and their high level when

on) to a negative chase (steps are at their high level when off and their low

level when on). All effects must have either the positive or negative

attribute assigned (all other attributes are optional).

Previous Page is softkey [S4] in many displays

Press [S4], Previous Page, to go backward one display page.

Print Screen

Print Screen is softkey [S1] in the Load Management display

Press [S1], Print Screen, to print a list of dimmer load errors.