User manual

chapter 3 system settings 23
Set Master type
You may set the Master slider (labeled Grandmaster on older Expression
2 line consoles) to one of three control options.
• Disabled
Master slider does nothing.
• Grandmaster
Master slider controls all levels on stage except parked channels and
independent channels.
• Sub Grandmaster
Master slider controls all levels on stage set by submasters.
To configure your Master slider, follow these steps:
Set Channels/Submasters 1-to-1
Set Channels/Submasters 1-to-1 sets your console’s channels to a one-to-
one match with your submasters. Thus, channel 1 is patched to submas-
ter 1, channel 2 to submaster 2, and so on. Channel levels are set to Full
and up/dwell/down times are set to 1/Manual/1.
To reset your channels and submasters, follow these steps:
Keystrokes: Action:
1. Press [Setup].
Displays Setup menu
2. Press [1], System Settings,
[Enter].
Displays System Settings menu
3. Press [1][0], Master Type,
[Enter].
Prompt reads:
Select master type and press
ENTER (0 = Disabled,
1 = Grandmaster,
2 = Sub Grandmaster)
4. Press [1] [Enter].
Master is set as Grandmaster
Keystrokes: Action:
1. Press [Setup].
Displays Setup menu
2. Press [1], System Settings,
[Enter].
Displays System Settings menu
3. Press [1][1], Set Channels/
Submasters 1-to-1, [Enter].
Prompt reads:
Select page to default, then press
ENTER (1 = Page 1, 2 = Page 2,
0 = All pages)
4. Press [Enter].
Channels are assigned to submasters.
The display returns to Setup menu