User manual

22 Insight 2x user manual
Enable/disable Flexichannel
Insight 2x’s Command display can be set to operate in full display mode
or in Flexichannel mode. In full display mode, channel displays show all
channels and their current status. In Flexichannel mode, only channels
with a recorded level or that are on the Link List appear. Insight 2x defaults
to full channel display.
Follow these steps to enable or disable Flexichannel:
Updating Flexichannel
When channels that were used in a show are removed from the show,
they remain on the channel list until it is updated. The Purge Flexi softkey
on the System Settings display updates the list of used channels. The list
is also updated when you load a show from diskette, or when you first
turn Flexichannel on. Press [Setup] [1] [Enter] [S1], Purge Flexi, to update
Flexichannel displays.
Keystrokes: Action:
1. Press [Setup]. Selects Setup display
2. Select [1], System Set-
tings, and press [Enter].
Selects System Settings menu
3. Select [9], Flexichannel,
and press [Enter].
Prompt reads:
Enable/disable flexichannel
(1 = Enable, 0 = Disable)
4. Press [1] or [0]. Corner reads:
Flexi 1
Or...
Flexi 0
5. Press [Enter]. Flexichannel mode is enabled or dis-
abled