User manual

appendix a installation 317
Installing Infrared Remote Focus Unit
The optional Infrared Remote Focus Unit (IRFU) allows you to set channel
levels, check dimmers or run cues from remote locations in your studio or
theatre. The IRFU consists of two components; a receiver and a transmit-
ter. The receiver is connected to the console with a standard multi-con-
ductor cable. The transmitter is a hand-held, wireless unit that sends
infrared control signals to the receiving unit.
To install the infrared remote control unit, follow these steps:
1. Verify that the receiver unit is properly connected to the console and
that battery in transmitter is good. (See infrared remote documenta-
tion for correct connection procedure.)
2. Press [Setup].
3. Select 6, Options Settings, and press [Enter].
4. Select 4, Infrared Remote, and press [Enter].
5. Enter 1 to enable the IRFU or 0 to disable the IRFU. Press [Enter].
6. Press [On] key on the transmitter unit to turn power on. (Transmitter
power automatically shuts off if no keys are pressed for three min-
utes.)
IRFU console connector
DIN 5-pin female
IRFU pinout
1 Ground
2 PPM data
3 +12V
4 WSI data
5 Charge current