User manual

appendix a installation 307
ETCNet cabling DIP switch settings
Before you use the console on the ETCNet network, set the ETCNet DIP
switches as described below.
1. Locate the DIP switches on the back panel of the console, to the left
of the ETCNet connector(s).
2. Set DIP switch 7 to indicate what kind of wiring you are using.
DIP 7 Wiring type/connector
Up BNC (ThinNet) connector
Down RJ45 (Twisted Pair) connector
3. Set DIP switches 2 and 3 to indicate ETCNet network status. (If you
are using Full Tracking Backup, the switches also determine which
console is A and which is B).
DIP 2 DIP 3 Console mode on start up
Up Up Network off
Down Down Network on/Single console
Down Up Network on/FTB Console A
Up Down Network on/FTB Console B
4. If you are using Twisted Pair wiring, it may be necessary to change
the setting of DIP switch 8. If you are using an external null concen-
trator, set DIP switch 8 up. If not, set the switch down.
DIP 8 Twisted Pair Polarity
Up Off
Down On