User manual

306 Insight 2x user manual
ETCNet
Insight 2x supports ETCNet, a specially designed network that allows you
to connect a wide variety of ETC interface devices to the console at
remote locations. Through these devices, you can attach monitors,
DMX512 devices, RFUs, alphanumeric keyboards, and Designer’s Work-
sheets to the network. Interface devices include the Remote Interface
and the Remote Video interface
ETCNet connectors for two or three types of ETCNet wiring are located
on the back panel of the console and all ETCNet interface devices. The
connector you use will depend on what kind of wiring your location has
installed.For more information about wiring choices, see the ETCNet Plan-
ning and Installation Guide
.
To attach Insight 2x to the ETCNet network, insert the connector at the
console end of the network cable into the appropriate console connector
(BNC, RJ45, or 15-pin). Attach other devices to the interface device as
described in the appropriate sections of this manual.
Note: For continued compliance with emissions requirements, all cables,
with the exception of twisted pair cable, must be shielded.