User manual

304 Insight 2x user manual
MIDI Out/Thru jumper setting
You may set the MIDI Out connector as a MIDI Thru port. Follow these
steps to do so:
1. Locate the jumper at location J5 (J8 on Insight 2x) on the face panel
circuit board in the lid of the console. With the lid in an upright posi-
tion, the jumper should be near the lower right corner of the circuit
board.
2. The jumper at location J5 (J8 on Insight 2x) should be installed on the
pair of pins labeled 1 (A on Insight consoles) for MIDI Out to be active.
To use the MIDI Out connector as a MIDI Thru connector, move the
jumper to the pins labeled 2 (B on Insight 2x).
On older consoles (with keyswitch power switches), the jumper locations
are slightly different. Follow these steps with older consoles:
1. Locate the jumper at location J7 on the face panel circuit board in the
lid of the console. With the lid in an upright position, the jumper should
be near the lower right corner of the circuit board.
2. The jumper at location J7 should be installed on the pair of pins
labeled A for MIDI Out to be active. To use the MIDI Out connector
as a MIDI Thru connector, move the jumper to the pins labeled B.
3. Close the console and test for proper operation.