User manual

appendix a installation 303
Installing MIDI
Connect Insight 2x to any MIDI equipment using a standard MIDI cable.
There are three round, 5-pin, DIN-type connectors labeled MIDI In, MIDI
Out, and Keyboard on the back of the console. Turn console power off,
then connect the cable from the MIDI Out of the electronic instrument or
sequencer to the MIDI In on the console. Connect the cable from the
MIDI In on the instrument or sequencer to the connector labeled MIDI
Out.
Warning: Do not plug the MIDI cable into the connector labeled Key-
board. This connector is for use with an optional alphanumeric keyboard
and may damage MIDI equipment.
If you like, you can set the MIDI Out connector as a MIDI Thru port. See
next page for more information on this option.
Follow these steps to connect MIDI equipment to Insight 2x:
1. Turn console power off.
2. Insert standard MIDI cable into the connector on the back of the con-
sole labeled MIDI In . Do not insert MIDI cable into connector labeled
Keyboard.
3. If you are sending MIDI commands from the console, insert another
standard MIDI cable into the connector on the back of the console
labeled MIDI Out.
MIDI console connectors
DIN 5 pin female
MIDI pinout
1 not connected
2 Ground
3 not connected
4 MIDI +
5 MIDI –