User manual

appendix a installation 301
10. Press [7], Designer’s Worksheet Setup [Enter] . Insight 2x displays
the Designer’s Worksheet Setup Menu.
11. Select one of the displayed options, either on the console keypad, or
by selecting [F2], [F3], or [F4] on the Worksheet template button bar,
then press [Enter].
12. Press [S1], Sheet/Console Sliders, to enable slider control from
either the digitizer or the console.
13. Touch the pen to the digitizer region labeled Calibrate (or [F1]).
14. Follow the instructions on the screen that direct you to touch the pen
to the regions labeled A, B and C.
Designer’s Worksheet DIP switch settings
Three sets of DIP switches are located on the back panel of the Kurta IS/
ONE Designer’s Worksheet. These DIP switches need to be set as shown
below for the digitizer to function properly. The Kurta XGT Designer’s
Worksheet does not have DIP switches.
Note: These settings are different from those used with old Expression-
line consoles.
To change the DIP switch settings, find the switches and adjust the set-
tings as shown on the illustration and chart below.
The Designer’s Worksheet checks DIP switch settings when unit is
turned on . You must restart the unit for new DIP switch settings to take
effect.
Switches are either Up (On) or Down (Off).
1 2 3 4 5 6 7 8
Set A Down Down Down Down Up Up Up Up
Set B Down Up Down Up Down Down Up Up
Set C Up Up Down Down Down Down Up Down