User manual

appendix a installation 291
Older console DIP switch settings
A set of DIP switches are located inside older consoles (with keyswitch
style power switches) at the back right corner of the circuit board, to the
left of a strip of eight LEDs. The settings of DIP switches 2 and 3 deter-
mine whether your system is using ETCNet and Full Tracking Backup. DIP
switch 4 enables SMPTE.
To change the DIP switch settings, raise the top panel and hold it in
upright position. Find the switches and adjust the settings as shown on
the list below.
Insight 2x checks DIP switch settings when the console is turned on. You
must restart the console for new DIP switch settings to take effect.
Switches are either On (Closed) or Off (Open). DIP switches 1, 5, 6, 7,
and 8 should always be Off
.
DIP Switch Function
1 Factory Use Only
Off (Open) Should always be set
2 3 Console mode on start up
Off Off Network off
On On Network on/One console
On Off Network on/FTB Console A
Off On Network on/FTB Console B
4 SMPTE
Off (Open) SMPTE disabled
On (Closed) SMPTE enabled
5 through 8 Factory Use Only
Off (Open) Should always be set