User manual

appendix a installation 289

Node Board - Revision A

The Revision A Node Board appears in Remote Interfaces. It contains one

8-switch DIP switch unit and a set of 14 jumpers.

Before you use the device on the ETCNet network, set the ETCNet

cabling jumpers to indicate what kind of cable the network uses. To set

the jumpers, follow these steps.

1. Locate jumpers 1 through 14. (See illustration above.)

2. If your network cable is plugged into the BNC connector (ThinNet),

install jumpers 1 through 6. Be certain jumpers 7 through 12 are not

installed.

3. If your network cable is plugged into the RJ45 connector (Twisted

Pair) or the DB15 connector (ThickNet), install only jumpers 7 through

12. Be certain jumpers 1 through 6 are not installed.

4. Jumper 13 must always be off. Jumper 14 should always be installed.

4052B4014 REV. A

MADE IN THE U.S.A.

Jumpers

Video card

ETCNet card

DIP

switches

Main Processor

1 2 3 4 5 6 7 8

Open

ETC part number

Revision