User manual

appendix a installation 287
DIP switches and jumpers
Several components of the Insight 2x system contain DIP switches which
must be set properly in order for the system to function properly. The DIP
switch settings for the following components are listed in this appendix,
along with instructions for changing them. New DIP switch settings take
effect when you turn on the console.
Setting DIP switches
Insight 2x checks DIP switch settings when the system is turned on. You
must restart the console for new DIP switch settings to take effect.
Switches are either On (Closed) or Off (Open). Two varieties of DIP
switch are used in the Insight 2x. In one, the switches extend above the
surface of the unit. You may use your fingers to set these switches. The
other contains switches that are recessed into the unit. You will need to
use a pin or other fine-pointed object to change the switch settings.
Setting jumpers
A jumper is a small plastic connector used to join a pair of pins sticking out
of a printed circuit board. The jumper is installed when it covers both pins.
It is not installed when it covers one or none of the pins (see illustration
below).
Jumper Jumper
not installed installed