User manual

chapter 21 moving lights 267
Setting up a link
To set up a link, you must assign at least one channel to the X channel list
and one channel to the Y channel list. In the following example, two color
scrollers are linked so that their color settings are controlled by the wheel.
For the two scrollers, color is controlled by channels 1 and 11, respec-
tively.
To link two channels, follow these steps:
Keystrokes:
Action:
1. Press [Setup] [1][1] [Enter].
Selects Channel Attributes display
2. Press [S7], Link List.
Selects Link List display
Prompt reads:
Select link number
3. Press [1] [Enter].
Selects link 1.
Prompt reads:
Select X channel number(s)
(Precede with AND to add to
existing link, or EXCEPT to delete
from link
4. Press [1] [→].
Channel 1 is assigned to the link’s X
list
Prompt reads:
Select Y channel number(s)
(Precede with AND to add to
existing link, or EXCEPT to delete
from link
5. Press [1][1] [→].
Channel 11 is assigned to the link’s Y
list. Link entry is complete
Prompt reads:
Select fixture type, then press
ENTER (1 = XY position, 0 = other)
6. Press [0] [→].
The link sets the trackpad to double
mode. Link entry is complete