User manual

chapter 20 control interfaces 261
Manual playback
The Manual Mode, Pause Mode, and Step softkeys allow you to manually
control playback of SMPTE events with no external SMPTE time input and
without the console’s internal clock. [Time] allows you to select an event
by specifying its SMPTE time.
Follow these steps to select and run SMPTE events out of recorded
sequence.
Note: Always press [S3], Manual Mode, or [S4], Pause Mode, to interrupt
SMPTE code when you are programming the console. This prevents
SMPTE events from running while you are working.
Keystrokes:
Actions:
1. Press [Setup].
Selects Setup display
2. Press [1][3], SMPTE
Events, and press [Enter].
Selects SMPTE Events display mode
3. Press [S3], Manual Mode
or.. .
Press [S4], Pause Mode,
Interrupts SMPTE input and resets the
console to the first recorded SMPTE
event,
or...
Interrupts SMPTE input at current
SMPTE event
4. Press [S5], Step.
Advances to the next recorded
SMPTE event, (In Manual mode,
pressing [Step] starts with the first
recorded SMPTE event)
5. Repeat step 4 to advance
sequentially through
SMPTE events.
6. If you are in Manual mode,
press [S3], Manual Mode.
If you are in Pause mode,
press [S4], Pause Mode.
Returns to normal operation and the
flow of SMPTE code resumes