User manual

chapter 20 control interfaces 259
Playing back the SMPTE program
The console allows you to play recorded SMPTE events in several ways.
You may use any external source of SMPTE data to run the program, you
may run the program using the console’s built-in SMPTE clock, or you may
play individual events manually.
Note: As you play back SMPTE programs, you may find it useful to display
the SMPTE event list on the playback display. To do so, press [Setup] [6]
[Enter] [7] [Enter] [1] [Enter].
External SMPTE source
Once you have recorded a series of cues in a SMPTE program, the con-
sole automatically runs the program in response to SMPTE time code. To
run the SMPTE program, start the flow of external SMPTE data.
Before you start SMPTE flow, you must enable the SMPTE port. To do so,
follow these steps:
When the console detects SMPTE data, it will automatically run the
SMPTE program. If external data is not detected, and the internal clock is
disabled, the message Waiting for input appears above the SMPTE list.
Keystrokes:
Actions:
1. Press [Setup].
Selects Setup display
2. Press [6], Options Set-
tings, and press [Enter].
Selects Options Settings menu
3. Press [5], SMPTE Input,
[Enter].
Prompt reads:
Enable/disable external SMPTE
input (1 = Enable, 2 = Disable)
4. Press [1] [Enter].
External SMPTE is enabled