User manual

chapter 20 control interfaces 257
Editing events
Each event in a SMPTE program may contain a combination of cues,
macros and submaster bump buttons. Each of the cues and submasters
may have a rate applied, and the event may be labeled for easy identifica-
tions. You may add, change or delete any of these items from an event by
following these steps.
Range editing
If you wish to apply a change to a range of events, you may select multiple
events and edit them all in a single step. For example, if you wanted to set
the rates for your first ten events to 50 percent, you could do so by follow-
ing these steps:
Keystrokes:
Actions:
1. Press [Setup].
Selects Setup display
2. Press [1][3], SMPTE
Events, and press [Enter].
Selects SMPTE Events display mode
3. Use the arrow keys to
highlight the field of the
item you want to edit.
Selects field to edit
4. Enter the new contents of
the field. If you wish to
delete the item, press
[Clear].
5. Press [Enter], or use the
arrow keys to select
another field.
Keystrokes:
Actions:
1. Press [Setup].
Selects Setup display
2. Press [1][3], SMPTE
Events, and press [Enter].
Selects SMPTE Events display mode
3. Press [S7] until [S1] reads
Select Event.
4. Press [S1], Select Event.
Prompt reads:
Select SMPTE event number
5. Press [1] [Thru] [1][0].
6. Press [S4], Rate.
The first rate field is highlighted
Prompt reads:
Select SMPTE A/B Rate
7. Press [5][0].
Sets the rate to 50 percent
8. Repeat steps 6 and 7 for
the remaining rate fields.