User manual

252 Insight 2x user manual
Reset Loop time
The SMPTE program loop plays from the first event time to the last event
time, then resets and plays again. The first and last times are displayed in
the upper right corner of the display, and may be set by the user. Any
events with SMPTE times before the first time or after the last time will
not play.
Note: A SMPTE loop can last from five seconds up to 24 hours. If the loop
is set to be less than five seconds, the internal clock resets it to five sec-
onds from the loop’s starting time.
To set or change the first and last event times, follow these steps:
Keystrokes:
Actions:
1. Press [Setup].
Selects Setup display
2. Press [1][3], SMPTE
Events, and press [Enter].
Selects SMPTE Events display mode
3. Press [S7] until [S8] reads
Reset Loop.
4. Press [S8], Reset Loop.
Prompt reads:
Enter first valid frame of SMPTE
internal time, then press ENTER.
(Press TIME to edit specific fields)
5. Press [1][0][0][0]
Sets ten seconds as the starting time
for the SMPTE show
6. Press [Enter].
Prompt reads:
Enter last valid frame of SMPTE
internal time, then press ENTER.
(Press TIME to edit specific fields)
7. Press [5][0][0][0][0] then
press [Enter].
Sets the SMPTE show to reset at the
five minute mark