User manual

chapter 20 control interfaces 245
Enabling DMX In
To enable the console to accept DMX512 input, follow these steps:
Note: On Insight 2 consoles the submaster sliders must be in Submaster
Mode to enable DMX In. Use the [Sub Mode] key to set the sliders to Sub-
master Mode.
Keystrokes: Action:
1. Press [Setup]. Selects Setup menu
2. Press [6] [Enter]. Selects Options Settings menu
3. Press [3] [Enter]. Prompt reads:
Select DMX512 In starting channel
(Enter 0 to disable)
4. Enter the first channel to
be controlled by DMX In
and press [Enter]. See
DMX In starting channel
on page 244 for more
information.
Enables DMX In and selects desired
starting channel
5. If submaster 108’s red
LED is flashing, move its
slider to 10, then to zero. If
its green LED is flashing,
move its slider to zero.
The DMX In slider is set to control DMX
In; red and green LEDs both light