User manual

238 Insight 2x user manual
MSC commands received by Insight 2x
Insight 2x consoles enabled for MSC accept the following MSC com-
mands. When the console receives one of these commands, it executes
the command immediately. In order to accept MSC commands, the con-
sole’s receiver Device ID must match the target device ID for the MIDI
device sending the signals.
Go If no cue number is sent, Go presses [A/B Go] on Insight
2x. The next cue on the cue list runs in the A/B fader.
If a cue number is sent, the specified cue runs on the A/
B fader.
If a cue number is sent, and 2 is sent as the list entry,
that cue runs on the C/D fader.
If cue 0 is sent, and 2 is sent as the list entry, the com-
mand presses [C/D Go]. The pending cue runs in the C/
D fader. You may also press [A/B Go] by sending Go-
Cue 0-1.
Stop The Stop command by itself holds all fades in both fader
pairs.
If Stop is sent with a cue number and a list entry of 1,
only the cue running in the A/B fader holds.
If Stop is sent with a cue number and a list entry of 2,
only the cue running in the C/D fader holds.
The cue number field is ignored, but must be included if
a list entry is sent.
Resume The Resume command by itself resumes all holding
fades in both fader pairs.
If Resume is sent with a cue number and a list entry of
1, only a cue holding in the A/B fader resumes.
If Resume is sent with a cue number and a list entry of
2, only the cue holding in the C/D fader resumes.
The cue number field is ignored, but must be included if
a list entry is sent.
Fire The Fire command executes a specified macro. Macro
number must be in the range 1-127. If no macro is spec-
ified, or if the macro number is out of range, the com-
mand is ignored.