User manual

chapter 20 control interfaces 233
Configuring ETC MIDI
The console must be configured to operate in MIDI mode. If you have any
questions about this, please contact your dealer or ETC.
Once the console is on, the MIDI Channel must be set. Select 1, ETC
MIDI Channel in the Options Settings menu.
The console operates at all times in MIDI Mode 3 or Omni = off/Poly. This
means it only receives or transmits MIDI commands on the user-selected
channel. The Select MIDI Channel function allows the user to specify the
desired channel. Insight 2x ignores all MIDI commands on channels other
than the specified one, so be sure your MIDI gear is set to the same chan-
nel. The console remembers the selected MIDI channel the next time it is
turned on.
Follow these steps to configure Insight 2x for MIDI use:
1. Turn console on.
2. Press [Setup] to display Setup menu
. Then select 6, Options Set-
tings, and press [Enter] to display the Options Settings menu. The fol-
lowing display appears:
3. Select 1, ETC MIDI channel, and press [Enter]
.
4. Enter the MIDI channel you will use (1-16), and press [Enter] . Verify
that your MIDI equipment is also set to the same channel . Insight 2x
will ignore MIDI commands on other channels. Press [S1], Disable
MIDI, to disable ETC MIDI mode.