User manual

230 Insight 2x user manual
Disabling secondary messages
You may prevent secondary ETCLink advisory messages from being dis-
played while you are operating the console. This is done from the ETCLink
Functions menu.
For example, if you are rehanging a show, a large number of load errors
will be generated despite the fact that nothing is actually wrong. Under
these circumstances, you might want to turn off the secondary messages
until the show is completely rehung and the new loads have been
recorded. This would allow the board operator to use the console uninter-
rupted.
Note: See page 324 for a list of secondary messages.
To disable advisories, follow these steps:
Keystrokes:
Action:
1. Press [Setup].
Selects Setup display
2. Select [9], ETCLink Func-
tions, and press [Enter].
Selects ETCLink Functions menu
3. Select [6], Display Advi-
sories, and press [Enter].
Prompt reads:
Enable/disable display of ETCLink
advisories
(1 = Enable all, 2 = Enable fatal error
advisories only, 0 = Disable)
4. Press [0] [Enter].
All ETCLink advisories are disabled; to
enable advisories, follow the same
steps, but select 1 or 2 in step 4