User manual

216 Insight 2x user manual
Enabling ETCLink
Before using ETCLink functions, you must connect the system to the
ETCLink network. Follow these steps to activate your ETCLink connec-
tion, allowing you to monitor the dimming system:
Note: If you change the ETCLink address, you must cycle power to the
console before the new address will take effect.
Enabling ETCLink messages
If you wish ETCLink advisory messages to be displayed while you are
operating the console, you must enable them from the ETCLink Functions
menu.
To enable advisories, follow these steps:
Note: To disable some or all advisories, follow the same steps, but select
0 or 2 in step 4
Keystrokes:
Action:
1. Press [Setup].
Selects Setup menu.
2. Select 6, Options Set-
tings, and press [Enter].
Selects Options Settings menu
3. Press [8], ETCLink,
[Enter].
Prompt reads:
Enable/disable ETCLink
(1 = Enable, 0 = Disable
4. Press [1] [Enter].
Dimmer Monitoring is enabled
5. If you wish to change the
ETCLink address, press
[9], ETCLink Address,
[Enter].
Prompt reads:
Select ETCLink address
6. Press [1] [Enter]. (ETCLink
address may be 1 or 2.)
ETCLink address is changed
Keystrokes:
Action:
1. Press [Setup].
Selects Setup display
2 Select [9], ETCLink Func-
tions, and press [Enter].
Selects ETCLink Functions menu
3. Select [6], Display Advi-
sories, and press [Enter].
Prompt reads:
Enable/disable display of ETCLink
advisories (1 = Enable all, 2 = Enable
fatal error advisories only,
0 = Disable)
4. Press [1] [Enter].
All ETCLink advisories are enabled